Introducing the HeliBars® TracStarTM Triumph® Daytona® 675 handlebar riser clip-ons by Heli Modified, Inc. An innovative design with improved street comfort.

Heli Modified believes you should have your cake and eat it too because, "Performance shouldn't be painfulTM"

Our design guru, Harry Eddy, has once again applied his 360° DesignTM approach to produce the first in a new line of one piece alloy HeliBars.

CNC carved from a single 6061 extruded aluminum billet, the new TracStarTM clip-ons allow optimal placement of controls in a cramped environment. Because there are no handlebar tube mounting clamps attached to the fork tube clamps, the master cylinders and switch gear can be mounted closer to the top triple clamp. This single feature optimizes bar angles, height and width changes.

The first recipient of the new TracStarTM HeliBars is Triumph's® awesome new Daytona® 675.

"The 675 is a balance act that will be hard to follow. It is the most compact and well balanced sport bike I've owned. The only thing this machine needs is my new taller, flatter and wider TracStarTM bars."

-42.5 mm (1.670") taller at the damper end

-10 mm (3/8") taller at the fork tube

-25 mm 1" wider at 27 inches

-One piece seamless design

-As always, pre drilled for control housings. A true direct replacement design.

-Retains factory damper weights

-Billet reservoir mount included

-Retains all stock cables and hydraulic lines

-No modifications to install

-45 minute installation time

2004-2008

Also new for  the Triumph Thruxton clip-on Heli Bar. Designed to dramatically increase comfort while maintaining a slight forward lean for good peg, seat, and bar dynamics. Direct replacement.

-Bolt-on design

-4 3/4 Taller

-2" Rear offset, adjustable by 2"

-No modification of the headlight mount required

-Retains all stock cables and hydraulic lines

-Silver powder coat finish

-Hollow bar ends - accepts many types of bar end dampers or mirrors

Bar position has been raised 4 3/4" from the stock position. Downward angle has been reduced by 4? for a very natural wrist angle. (see picture)

Our clamp design is CNC cut from solid mill spec low carbon steel. The locating bolt which positions the stock bars is retained and we have slotted the hole to allow a 2" rotation adjustment of each bar.